During our 29 years in the industry, we have observed many misrepresentations of Rife technology. At some point, I believe, some things have been taken for granted. We assume in a general way that all targets, organic or inorganic, have very specific frequencies. Thousands of cases suggest that this is a truism; and yet it is a gross over simplification.
Although it’s true that the simple model is close enough in the average case to get the result, there are enough non-average cases to suggest that we cannot rely on the simple model in practice. It would be extremely nice if Rife technology were really as straightforward as setting a frequency and bingo, there you are. Sadly no. Not only is it far more involved, it is also a moving target.
The correct frequencies for any specific microorganism are determined by the following variables in order of their importance:
Background (or ambient frequency, or pre-load)
Each is broken down into a spectral gradient, and each can be at any point in the gradient at any time, so the mix creates a huge number of possible relevant variables. And, unfortunately, there is always the unknown variable X.
In reality none of this information can be readily determined, so the science involved is superfluous. It cannot be calculated accurately in any reasonable time, nor would it be cost effective. A complete failure might likely occur in the case of unknown size, sensitive location, low hydration, or desiccated tissue, complex pharmaceutical and other toxic chemistry, low conductivity, intense background radiation (such as cell phone towers, and other radio sources), low temperature/blood pressure, and a long history of unsuccessful exposure to the therapy, resulting in a highly resistant strain.
In the basic use of the technology, there are two kinds of energy of which the user should be aware: Migration current and diffusion current. The migration current is the part of the energy that you can easily feel; and the diffusion current is the part of the energy that you cannot feel, because it is too diffuse in the body for the nerves to detect.
Presumably, the migration current is powerful enough to electrocute virtually any single-celled microorganism if adequate power is delivered at any frequency in the therapeutic range. The diffusion current is far less concentrated, thus tuning refinement is vital. In general, the migration current is applied locally and diffusion current is applied systemically. (For example, via hands and/or feet.) So the optimum effect, logically, is when we deliver the migration current at vital, or mortal frequency. But as I have said, it’s not really as simple as we would like it to be. It’s possible to do everything right and still fail, due to any of the aforementioned variables.
To compensate for these variables, we have created the General Alignment recordings to anticipate the potential variables. And we address them systematically, in order to normalize the affected area and finally achieve the desired result.
Tissue adaptation phenomena is the most common problem in “civilized” regions. Adaptation in the affected areas is due to its extreme environmental conditions over time. The scale is tipped to the edge in one or more of the relevant variables long enough to allow the person/organism to adjust to the presence of the parasite, in which case the body protects the offending pathogen and may in some cases still emulate it and or its symptoms, even after the pathogen has been eliminated. Something akin to mal-debarkment.
What this alludes to is a sequence of events. A standardized method of normalizing the body and the areas of infection to permit a more normal effect and reaction, not only to frequency therapy, but virtually any effective therapy. My expectation is 100% success in all cases with a correct diagnosis, and provided adequate therapy with our JWLABS Model A device.
People fail. The therapy cannot.
Note that we deliver frequencies which have been manually tuned with precision that is unmatched in the industry. From our analog Model B device, tuning is refined to as much as a billionth of a hertz. This, plus the ease of use of our Model A devices (which delivers the frequency sessions) continues to set JWLABS apart as significant contributors the the development of Rife technology.
To learn more, explore our web sites:
UPDATE: We have launched our latest development in Rife technology. Model A4 is the first and only touch-screen Rife machine. Access our full library of hand-tuned frequency sessions which are on board the machine. Learn more HERE.